Electric Motors
Water Pumps
|
PBG pump
|
Range of Performance
Flow rate up to 120L/min (7.2m3/h)
Head up to 8 m
Working Condition
Liquid temperature: 2 - 110oC
Ambient temperature: 2 - 40oC
The former temperature must be higher than that of the latter so as to avoid short circuit caused by dewing on the pump body.
Max. Working pressure: 10 bar
Application and Installation
The pump can be used to delivery soft water, thin, clean, non-corrosive, non-explosive liquids without solid granules, fibres and mineral oil for circulation pipeline, water-heat system and obturation-patterned industrial circulation system.
The pumps shall be installed in enclosed places, or at least protected against inclement weather.
Structure Feature
Pump body: Cast iron
Motor Bracket: Aluminum
Impeller: Plastic
Motor shaft: Ceramic
Sealed part: Shielding can
Electric motor: Single-phase 220V - 50Hz with capacitor and thermal overload protector. Voltage fluctuation for 10% more or less is allowed and other voltage for 60Hz is also available.
Insulation: Class H, F
Protection: IP44 for XPS3-6, IP42 for XPS7-7 |
|