SITE MAP | ||||||
|
RANGE – P NEETER DRIVE BEVEL GEARBOXES
|
Generally comprising of the same basic design characteristics as the range of right angle gearboxes with the added facility, within the housing, for manual disconnection or “reversed rotation” re-engagement of the output drive shaft. This is effected hand rotation of a control knob located on one side of the housing to provide 3 positive control positions. The control knob can engage with the power train of 3 straight bevel gears.
“Central position” the drive output is fully disconnected allowing it to “idle” or “free-wheel”
“Left-position” engagement in one direction to provide forward output rotation.
“Right position” engagement in the other direction to provide reverse output rotation.
Note: manual engagement & disengagement must ONLY be carried out when all shafts and, particularly, the output shafts are stationary (unless, both driving and driven inertias are small – and, even then, speeds should not exceed 200 RPM).